The Cisco 7200 VXR routers support the high-speed network processing engine, NPE-G2, and all otheravailable network processing engines. The NPE-G2 provides high-speed performance with theMotorolaFreescale 7448 1.67-GHz processor and supports three Gigabit Ethernet interfaces with no additionalbandwidth requirements. The NPE-G2 also provides a dedicated Fast Ethernet Management port and twoUSB ports for data storage and security tokens.The Cisco 7200 VXR routers also support high-speed network processing engines (NPEs) to provideincreased routing and process switching performance.The Cisco 7200 VXR routers with the NPE-G2, NPE-G1, NPE-400, and NSE-1 installed support both25-MHz and 50-MHz port adapter operation.NoteFor port adapter configuration information, refer to theCisco 7200 Series Port Adapter HardwareConfiguration Guidelines publication.The Cisco 7200 VXR routers accommodate a variety of network interface port adapters and I/Ocontrollers. Because both the NPE-G1 and NPE-G2 contain I/O controller functionality, they can be usedwithout an I/O controller installed. The NPE-G2 and NPE-G1 provide a third PCI bus, which enablesthe Port Adapter Jacket Card to be installed in the I/O controller slot to allow usage of an additionalhigh-bandwidth-usage port adapter.A Cisco 7200 VXR router equipped with an NSE-1 or NPE-400 can support up to six high-speed portadapters and can also support higher-speed port adapter interfaces including Gigabit Ethernet and OC-12ATM. The Cisco 7200 VXR routers also contain bays for up to two AC-input or DC-input powersupplies.The port adapters, I/O controller, and power supplies are the same for all Cisco 7200 VXR routers andare described in the“Field-Replaceable Units” section on page 1-10. The network processing enginesand network services engine are router model specific.The Cisco 7200 VXR routers support the following features:•Online insertion and removal (OIR)—Allows you to add, replace, or remove port adapters withoutinterrupting the system.NoteThe Port Adapter Jacket Card does not support OIR. However, the port adapter installed inthe Port Adapter Jacket Card does support OIR.•Dual hot-swappable, load-sharing power supplies—Provide system power redundancy; if one powersupply or power source fails, the other power supply maintains system power without interruption.Also, when one power supply is powered off and removed from the router, the second power supplyimmediately takes over the router’s power requirements without interrupting normal operation of therouter.•Environmental monitoring and reporting functions—Allow you to maintain normal systemoperation by resolving adverse environmental conditions prior to loss of operation.•Downloadable software—Allows you to load new images into Flash memory remotely, withouthaving to physically access the router, for fast, reliable upgrades.
DescriptionSpecificationMidplaneTwo primary PCI buses, and one secondary PCI bus•With an NPE-G2 or NPE-G1 and an I/O controller installed, the I/O controller does not usebandwidth points, and the NPE-G2 or NPE-G1 does use bandwidth points. The NPE-G2 orNPE-G1 does not use bandwidth points if installed without the I/O controller.•With an NSE-1, NPE-400, or NPE-300 installed: aggregate bandwidth of 900 Mbps1•With n NPE-100, NPE-150, or NPE-200 installed: aggregate bandwidth of 600 MbpsThree primary PCI buses—With the NPE-G2 or NPE-G1 installed, no I/O controller, and the PortAdapter Jacket Card installed, three PCI buses are available. Aggregate bandwidth of the PCI busesis 900 Mbps. The third PCI bus goes to the Port Adapter Jacket Card and provides unlimitedbandwidth for one port adapter.Dimensions(H x W x D)5.25 in. x 16.8 in. x 17 in. (13.34 cm x 42.67 cm x 43.18 cm)WeightChassis fully configured with a network processing engine or network services engine, I/Ocontroller, maximum number of port adapters, 2 power supplies, and a fan tray: ~ 50 lb (22.7 kg)Heat dissipation370W (1262 BTU2)Chassis fan noiselevels—single speedfanTested:•Front (I/O controller and port adapter side) 44.2 dB•Back (power supply side) 43.7 dB•Left (fan side) 47.2 dB•Right 44.8 dBMaximum: 65 dBaAirflow~80 cfm3Temperature32 to 104 F (0 to 40 C) operating; –4 to 149 F (–20 to 65 C) nonoperatingHumidity10 to 90% noncondensingPower SpecificationsAC-input voltage rating 100–240 VAC4 wide input with power factor correctionAC-input current rating 5A5 at 100–240 VAC with the chassis fully configuredAC-input frequencyrating50/60 Hz6AC-input cable18 AWG7 three-wire cable, with a three-lead IEC-320 receptacle on the power supply end, and acountry-dependent plug on the power source endDC-output power280W maximum (with either a single or dual power supply configuration)DC-input voltage rating –48 VDC8 nominal in North America–60 VDC nominal in the European Community